SOHC.co.uk Forums > CB350/400

Fork stud stripped.

(1/4) > >>

Bradders:
Afternoon all.  Took my front wheel off today but on replacing it one of studs seems to have a stripped thread. Was wondering how difficult it will be to replace and where’s the best place to buy them from. Regards.

Ken4004:


If there is any useable thread left you can run a die down the stud to recut the thread and then use two nut locked together to remove the stud.
The fork is probably held in with some form of loctite, these loctites are extremely strong bonds until heat is applied so the best course of action is to heat the forks not the stud with a hot air gun and then you should be able to remove the stud using the two nuts locked together.

I would think a new stud should be fairly easy to acquire on line.

Ken4004:
Just looked on line looks like CMSNL.com have these studs with giving them a call, look like M8 studs similar to the exhaust studs just a bit of a longer thread.

Bradders:
Thanks for your reply Ken. It gets worse, just tried to get the nut off and it just goes round and round doing nothing! So frustrating!

Bryanj:
Remove the other nut, put a screwdriver in the slot by the stripped one, lever the cap off whilst turning the nut, it should pick up the thread and undo

Navigation

[0] Message Index

[#] Next page