SOHC.co.uk Forums > CB350/400

Fork stud stripped.

<< < (3/4) > >>

Bradders:
Thanks Bryan. I would never of thought of doing it that way. Should I be able to do the job without dismantling the forks. When I put the new one in should I lock tight it in?

Bryanj:
No need to dismantle, personally i wouldnt locktite, you may need to take it out sometime!.
The hole is a blind hole so nothing should leak

Bradders:
Thanks Bryan for the info.

kevski:
As Bryan says, but it may already have some sort of thread lock in there so do not be surprised if it needs warming a little, when putting the new stud in apply a little threadlock on it, not arraldite or the likes of, the threadlock ensures the stud stays without being solidly glued in if you have to remove nut again.

Bradders:
Thanks Kevski, sounds like a plan.

Navigation

[0] Message Index

[#] Next page

[*] Previous page