SOHC.co.uk Forums > Project Board
Keiths 400/4
Coppertop1234:
New switch gears arrived and fitted
The quality of the DS replica seems decent and looks as good as originals
Slight disappointment the wiring is not matching to original - ok for me with the matching colour guide provided, but may be a problem for someone else at a future stage down the line.
I will make note on DS invoice of colour matching wires to keep in file.
mickwinf:
the thing that bugs me is costs the same to use the proper colours, so why use any others?
Coppertop1234:
Hi would some one be able to post me a few pics of horn mount from both sides.
Better to ask than bodge about trying this and that.
I made the previous mounts which fit and have the horn facing forwards under tank.
I have now got an original horn and fittings, but unsure if i have them all and how they go?
Got horn working and cleaned up, but do i have everything
pics of what i have.
I think
Short wire clip if rh side as a cable retainer for throttle cables?
Angled bracket is Left hand side and has a rubber cable retainer like battery box one fitted from frame to bracket?
Horn mounts on rh side flat to frame with fixed bracket 2 holes at top - no pic?
Where does taco retaining wire fit ?
cheers
keith
exvalvesetdabbler:
I think the forward facing horn was a requirement in some European countries. Netherlands being one.
The horn bracket goes on the right hand side, and on mine the cable tidy wire piece goes on the front mounting bolt.
The bracket for the rubber strap on the left, there should be a bit on the frame for the other end of the strap .
Don't bother until your done with plugs and tappets. It just gets in the way.
Regards
Dave.
exvalvesetdabbler:
The dealer setup manual will show you the cable routes. It's in Ash's Dropbox.
The tacho cable just dangles, clutch and throttle go through the clip.
Regards
Dave
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version