SOHC.co.uk Forums > CB500/550
What Special Tools Will I Need?
florence:
Is it a runner? Looks like it is in very good condition already.
Neilw:
--- Quote from: florence on January 30, 2026, 08:48:14 AM ---Is it a runner? Looks like it's already in very good condition.
--- End quote ---
It hasn't run for the last 4 yrs. It's been cosmetically tarted up by the previous owner, to a point to make it look good, but closer inspection shows there is rust on the frame, the seat underneath is rusted through, and the chrome on the mudguards is poor. I don't think there is anything major, but it depends on the engine.
The start button doesn't work, so that's my first priority to fix. The ultimate aim is to get it started and work from there.
Everything definitely needs good service.
Bryanj:
On that bike starter only works if neutral light on or clutch lever pulled in, that is unless wiring has been "doctored"
AshimotoK0:
If you ever need to remove the rear wheel bearing retainer....get a decent removal tool and don't forget its a left hand threaded part. I had to make up a beefy tool for mine with a 5 foot extension on it to get it to budge but I suspect mine had been Locktited, as well as staked in by a PO. I also made the mistake of stripping the rim and spokes prior to attempting to remove the retainer.
Murf:
A multimeter is a very useful thing to have if you are going to work on the electrics. You will also need a different bearing retainer removal tool for the front wheel if you plan to change its bearings.
A tin of midnight oil, heater for the garage, healthy bank account, understanding partner 😁
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version