SOHC.co.uk Forums > CB350/400
NLA carb parts
allankelly1:
Hi all
Just wondered please if anybody has had a go at fabbing these up?
Just started to strip down the carbs on the MH replica and these have had it, as gone very hard and brittle.
Was going to remake in 2mm black silicone rubber sheet and cut the shape / profile out on the wife’s circut machine once I have created a profile, as the design intent is just to keep out dirt from entering the sync assemblies but maintain that range of “adjustment”.
Just wondered please if anybody else has found an alternative solution?
Catchup again soon.
Best wishes Al
Sent from my iPhone using Tapatalk
Bryanj:
I have a vauge recolection of somebody on the US forum trying to make them years ago, no idea if it worked or not.
They never were available unless you bought a complete rack
Oddjob:
I’ve seen them included in a kit Honda made that also contained the alloy lifter arm that it seals against. There was a kit on eBay the other year with the part number clearly displayed but it wasn’t cheap at all.
XS850:
If anyone is into 3d printing I think it’s possible with TPU filament - 3d drawing might be problematic unless you’re proficient in CAD (or similar)!
Bruce
Rayzerman:
If just hard and gettting brittle, might be able to soften them up with a 50/50 mixture of wintergreen oil and isopropanol????
Navigation
[0] Message Index
[#] Next page
Go to full version