SOHC.co.uk Forums > CB750
750F1 gear change issue
neat street:
Thanks K2 K6 and Skoti, (K2 K6) problem is that when you take out the clutch spings ect, you have no drive from the clutch so it just turns freely... Skoti, thanks, that will be the solution to undoing, but now need to torque up and have to lock up? I am not sure how to do this without damage. Thank you both for your ideas and help.
Skoti:
--- Quote from: neat street on May 02, 2026, 01:19:36 PM ---Thanks K2 K6 and Skoti, (K2 K6) problem is that when you take out the clutch spings ect, you have no drive from the clutch so it just turns freely... Skoti, thanks, that will be the solution to undoing, but now need to torque up and have to lock up? I am not sure how to do this without damage. Thank you both for your ideas and help.
--- End quote ---
There's a special tool required for holding the clutch basket.
https://www.honda-classics.co.uk/shop/Tool-Set-Clutch-Basket-Holding-&-Centre-Nut-Tools-HWT052-p383119625
neat street:
Thanks Skoti, that makes sence, I will try and make something. appreciate your help
Bryanj:
If you imagine a set of mole grips with welded on legs turned at a right angle at the end that is what kawasaki sell to dealers as a clutch centre holder, have seen similar on fleabay will try and look
Bryanj:
Found one, pic of page attached, DO NOT ASK FOR A LINK i am too bloody old and tech non savy to do that.
There are cheaper on ebay and from foreign sellers just type into google kawasaki clutch centre holdin tool
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version