SOHC.co.uk Forums > CB350/400
Cam Tensioner Rod, Springs and Bolt
Athame57:
The last thing I heard is that the two springs the push rod passes through can lose their strength over the decades but I can find nowhere that can replace them so far.
Laverda Dave:
The last I heard was TTR400 only sells his horseshoe to DSS simply because the cost of P&P is too expensive to make it viable to post individually.
Bryanj:
You can get the manual tensioner from 4 into 1 in the us or on ebay from them,
Wrenchpuller:
Yeah i have one of the TTR400 horseshoes on standby, might just end up getting a TTR400 adjuster bolt and a pattern push rod.
I wonder if we knew the specs of the original springs we could get some made, would need to know the specific force of each spring as it was new though, which might be a stretch lol
Bryanj:
I bought a box of assorted compression springs on fleabay for about £6, you only need something to keep a small amount of tension if you use the TTR400 adjuster.
If you go direct to 4into1 its cheaper to buy but postage is a killer, you need a friend in us to act as middle man!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version