Other Stuff > Misc / Open

Superdream Front & Rear axle nuts - prices

<< < (3/4) > >>

Skoti:

--- Quote from: McCabe-Thiele (Ted) on September 20, 2026, 11:25:16 AM ---When torqued up I can't get the split pin hole anywhere near.
I guess a thinner spit pin is the answer as I don't want to overtighten it and strip the thread.

I can see me replacing the special washer and nut, thats another £25.00 for DS.

--- End quote ---

You'd have to be lucky to see the nut line up correctly to fit the split pin each time you torque it.

I usually pull it up a bit further or slacken it a touch until the split pin fits.

Or if you prefer it correctly torqued every time then you could dump the split pin and fit a re-useable lock nut, same as new Honda's have fitted and similar to what's listed below:-

https://hammerheadperformance.com/hammerhead-nut-m14-locking-flange-nut-9-220-014?srsltid=AU7gw4WxjjbVU7z0b4qMA5KPsBgySxu-CiypOF_7kUrx4WIMD9pBHEI3

https://www.cmsnl.com/honda-ca125-rebel-1998-w-germanykph_model1357/nut-u-14mm_90305ge8003/?utm_source=google&utm_medium=organic&cjevent=0e487b44b50111f1811f00da0a18b8fc

Good luck

   

McCabe-Thiele (Ted):
That's intesting Skoti - Hammerhead is a new one to me.

Skoti:
Just edited my above post to include a link for a genuine Honda lock nut.

But here it is again:-

https://www.cmsnl.com/honda-ca125-rebel-1998-w-germanykph_model1357/nut-u-14mm_90305ge8003/?utm_source=google&utm_medium=organic&cjevent=0e487b44b50111f1811f00da0a18b8fc

McCabe-Thiele (Ted):
Item not listed to fit the CB400NA presumably as it was not the original part.
It might fit, no flange o/d shown.

Bryanj:
I think they used to be called philidas nuts or something like that

Navigation

[0] Message Index

[#] Next page

[*] Previous page