SOHC.co.uk Forums > CB750

750K7 rebuild

<< < (2/3) > >>

Phil k:
Rob - nice looking build!

Which faces did you use on the clocks and how much of a pain were they to do?
(Did you use the dremmel or un-crimp method)??

Phil

AshimotoK0:
Rob - Soldered a new rectifier diode on today, will post it back tomorrow.

cheers

Ash

UKROBK7:
Thanks Ash, hopefully I will get it assembled and fitted over the weekend.

Phil, I used the faces off ebay USA (roberth9).  I used him as he was the only one that produced the dual scale (mph and km/h) type.
I cut the bezels off with a very fine tooth modelling hand saw that I had.  Fitting them was straight forward, lining up the overlays was the main problem as you need to "square them up" before letting them stick down.  I used JB Weld to fix the bezels back into place and used a round clamp overnight.  You have to paint your original faces white which sharpens up the lettering.
I wasn't pleased with the quality of the overlays at first.  He hand cuts them to size and they were slightly smaller than the original face and an iregular shape but this can't be seen when the front is in place.  The worst thing was that they are made with a matt uv protection film overlaid on them and there were air bubbles showing underneath.  When contacted he said he knew of the problem and it was the postal service bending the envelope that caused it!  He recommended putting the overlays in a thick book and clamping them up in a vice.  I did this and it worked.  Also the tacho scale is out of calibration when compared to the original but thats not noticeable and is not a problem now I know the error.  Now they are on I think they look fine and have the look of the originals.

Rob

AshimotoK0:
I do have some original faces with dual mph/kph for k7 and excellent red line, which I may be selling. waiting for a load of gauges to come from the states though before I part with them.

cheers

Ash

UKROBK7:
Will be in touch Ash.

Rob

Navigation

[0] Message Index

[#] Next page

[*] Previous page