SOHC.co.uk Forums > CB750

CB750 F2 carb venting

<< < (2/2)

K2-K6:
Good detail scottly, are those the "42" carbs specified for the F3 / K8 model designation  ? As we didn't get that iteration over here.

My feelings on float bowl vent and effectiveness:- the carb in reality should take zero air from float chamber, only fuel through the jets and with correct float /fuel height.

The need for free air is in absorbing the dynamic difference between draw (through jet use) and ability of the float valve to refill that volume promptly as it happens. In reality, very small huff-n-puff volume that's easily contained within existing equipment.

If the fuel tank breather were to be compromised , then it will try and draw air through float bowl route back up the line to "replenish" main tank, which would likely overwhelm the system and give fault.

I'd not forsee a problem of original (none of the F2 I was involved with when contemporary indicating an issue) specification if all parts were clear and functioning.

scottly:
I *think* the K7 carbs are PD41A? If the upper vents are blocked, it WILL cause issues.
This thread may be about the same carbs as Arch's?:
https://forums.sohc4.net/index.php/topic,181930.0.html

archmill:
Scottly, had a look at the thread and yes, those are the same vents as my carbs. the parts microfiche does show that they are linked together from carb to carb with tubes and the whole sysetem, as K2-K6 pointed out, vents through all 4 overflow tubes to the bottom of each carb.

scottly:
The bowl overflows and the bowl vents are 2 different things. Here is another thread on the topic. (The pictures were lost unfortunately.)
https://forums.sohc4.net/index.php/topic,195195.0.html 

Navigation

[0] Message Index

[*] Previous page

Go to full version