SOHC.co.uk Forums > CB750

Cam cover oil leak

(1/4) > >>

mo goldie:
Hi guy`s

I have just got a cb750 K4 for the first time and it`s got oil coming from the Cam cover at the front and running down the front fins of the Engine.....as I am not up much on them I wanted to know do any of you guy`s use a sealent on the gasket or just put it on Dry ? the thing I do know you can`t get the cam cover off without taken the engine out or doing things like the frame ralils cut and No way am I going to do that  :-X but you can get the old gasket off and the new one on while it is in the frame, as I just got the old one off......... I wonder if someone put the gasket on Wrong.....I have watched the YourTube video on one bloke saying about the little Nick in the gasket should be put on on the nearside of the bike...... but as said just wondered if anyone thinks it is a good Idea to put anything on it or Not......If so what would you use ? I use in most cases Wellseal so to use or Not to use ?

Cheers Mo

Skoti:
Take the engine out and fit a new genuine Honda gasket, make sure the surfaces are clean and dry before fitting the new gasket.

Absolutely use no gasket sealer whatsoever.


BTW

Have you checked the oil leak is not coming from the tacho drive oil seal?

Good luck.

McCabe-Thiele (Ted):
Trouble with sealant is removing it if you have to do the task again.

I have always used a light smear of grease on both surfaces, pretty sure many fit it dry.
For rubber type gaskets I use red rubber grease.

I also check the vent is clear as crankcase pressure will pump oil out.
.

Nurse Julie:
The prime suspect for leaks in this area are the pucks, (cylinder head oil seals). Even if it is just the gasket, the proper way to replace is remove the engine.

mo goldie:
Thanks All.

Well I will try the engine Not out first and see if I can do that and put gasket on "DRY" oh it is a Genuine Honda gasket.
I have a new tacho oil seal coming as I thought I would do that at the same time there was a bit of oil from there but Not much
..is that easy to get out the old one do you think ?

I have lots of other job to do on it so it will take me a while to sort it all out but will get back on my hours.......... oh taken the easy way first LOL  ;D

Navigation

[0] Message Index

[#] Next page

Go to full version