No photos or videos - but I have resolved it.
Part nos. 11 - the rubber bushes, had I think shrunk in height so that when it was all tightened up the nuts clamped part nos. 12 between the seat base and the washers (part nos. 17)… leaving the rubber bushes and thus all of the locking pin to flex all over the place.
So, I just filed down the part 12 spacers so that they just sat below flush with the height of the rubber bush. Now with it clamped up the pin is properly bushed rather than just rattling around.
A lot less wobble.
There is play between the pins and the hinge tubes on the seat - no wear is visible though on either of them, so I think that’s a case of ‘they are all like that’.