SOHC.co.uk Forums > CB350/400

Getting started/project CB350/400f

<< < (2/3) > >>

SteveD CB500K0:
You defo need a manual John...

I'll sort through my pdfs for a 350/400 book (most of mine are 500/550)   8)

SteveD CB500K0:
Sorry - not a 350/400 pdf in sight...

However, if you go to www.honda4fun.com they have them all there - pick and chose!

Go to "Materiale" and "Parts Lists" and "Manuali"
Steve

johndregg:
Thanks mate.

johndregg:

--- Quote ---Whilst the exhaust is off and the engine cold make sure the cam chain tensioner is working
--- End quote ---

Right i've had a look at this. Its the bolt down by the oil filter housing? I think mines been bodged. The adjusting bolt itself is ok but there is no lock nut, just an oversized nut spinning freely. I have to have another look at it, but i'm pretty sure someone has just ignored this for a lot of years.

Anyone got a pic of what parts should be there?

Progress made: New exhaust valves ground in and fitted.
                     NOS gasket set sourced and bought.


Going to try fitting the head tonight.

Bryanj:
DONT PUT THE HEAD ON YET if the rensioner is fubared its a bottom end strip to put it right and the engine is a lot lighter with the top off!!

Navigation

[0] Message Index

[#] Next page

[*] Previous page