SOHC.co.uk Forums > CB500/550
Make your own CB500 Clutch Pushrod / Push Rod
Trigger:
Bitsa, Had to have them made in the end because i could not find them anymore and the last one from the states cost me $75 + customs+++
Johnwebley:
--- Quote from: Trigger on November 07, 2014, 09:02:20 PM ---John, i have had a batch of pushrods made by a tool firm. I found a NOS one to take the blueprint from and had them made to the measurements in silver steel with hardened ends. If anyone require one i will sell at cost price to members.
John, the CB500 push rod is not 9.5mm. when i bought the NOS one i was still not sure that i had the right rod, so i got Oddjob to send me one to confirm the right size.
--- End quote ---
Hi Trigger,so the details from .net site are wrong,and a 3/8 steel bar will not fit?
obviously it will be easier to buy a ready made piece,
please let me know the cost,-))) Thanks
OOOPS !!!! just seen you message,will be in touch
Trigger:
--- Quote from: Bryanj on February 24, 2011, 05:15:22 AM ---The last genuine one i had in a Honda bag was one pice steel so i think thats the way as long as you aint racing as the extra weight will slow down the clutch operation.
To be pedantic one realy ought to use the correct diameter silver steel rod and harden the ends!
--- End quote ---
John, if you read the quote. Bryan is right. PM sent.
florence:
Do people still need these, I might have one from a rusty old bottom end I recently bought on ebay? Need to check the workshop carefully.
Bryanj:
So before i go looking for my last NOS one what was the diameter of the ones you had made Trig? I know the seal has an 8mm hole
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version