SOHC.co.uk Forums > CB500/550

Removing/changing main jets on 78 CB550K3

(1/2) > >>

stidds:
I have a 1978 CB550K3 with Kehin PD46C carburettors, I need to change the main jets, but I cannot see how to change them.

When I remove the main jets they are attached (very well indeed) to the emulsion tubes, my Haynes manual carb diagram show that they are pressed together with an O ring, now this must be a bloody good fit as I cannot see a join. 

Am I (well my manual) correct and that they need separating or am I missing something simple?

z1100r:

 Same to you as Mickwinf  see :- http://data.sohc4.net/SM500/HSM500550_16.pdf

mickwinf:
hi Sean the k3 is diffeent to the pics in the haynes manual the main jet just screws into the emulsion tube part with no seal, i just tried one off a spare carb. Mick

stidds:
Thanks guys, had a look and found it easy to remove.

I just didn't want to go in all guns blazing and screw something up.

andy_c101:
If your carbs are apart, I recommend you also take out the pilot jets as well for cleaning - especially if its been standing for a long time.
Thefine pilot jets ("slow jets") need to be clean to stand any chance of a smooth tick over, (in my experience).
& remember the pilot jets on the K3 are pressed in.
http://www.sohc.co.uk/index.php?topic=3283.msg12138#msg12138

Navigation

[0] Message Index

[#] Next page