SOHC.co.uk Forums > CB350/400

Clutch problem

<< < (2/3) > >>

Lynx:
Hi Ted,

I have exactly the same problem with my 400. Sorry to be a pain but could you give me the part numbers of the parts you had to replace? I've fitted new friction plates and check the metal plates are flat but no change. If anything it's worse.

ted_paper:
Hi Lynx,

I had the cam lifter assembly and thrust washer replaced.

I don't know if the individual parts are still available and got mine as a set from a used parts supplier.
Not sure whether it is good practice to put email addresses on here, so if you want his contact details, please pm. me.

I can send you a copy of the parts list too,  to help you identify them.

Lynx:
Hmm. Seems like none of that stuff is available anymore :'(.

My problem seems worse when hot. I just can't get it into neutral when stationary. So I thought it was probably a bent plate which was warping more when it got hot.
To try and sort this I've fitted new friction plates, checked spare metal plates for flatness and installed them, fitted a spare clutch basket with new damping rubbers and checked all those parts Ted mentions above. There is a little bit of wear on them but they don't look bad to me. I've checked it is adjusted right.

Any ideas anyone?

Lynx:
Thanks for the tips  Oddjob. I'll check it out.

Lobo:
Hi Lynx,

If wanting 'odd / unobtainable' bits Steve of

http://www.400fourbits.co.uk

often is able to supply... and occasionally breaks down assemblies as required... so you don't have to buy the full lot. Worth a look if you've not seen his website before...

Navigation

[0] Message Index

[#] Next page

[*] Previous page