SOHC.co.uk Forums > CB750

This looks Like a Sandcast to me !!!

<< < (2/3) > >>

AshimotoK0:
Got this reply on the Sandcast only site

mb69
Newbie
Posts: 33   
Re: Looks like a Sandcast to me but I am no expert !

Seamus:
Interesting as the engine number is right in the middle of the sandcast batch. How could the cases be replaced without changing the engine number?

UK Pete:
Numbers might be restamped on new blank cases,
This will be an interesting auction, lets have a guess at the finishing price, i say

AshimotoK0:
My UK K0 had replacement cases very early in its life under warranty because of chain breakage and the engine number pad is blank. If I ever get it finished :) I will stamp the engine with its original number, which is perfectly legitimate, as I believe having an engine number stamped in  is better than none at all.  Would not like to guess on the price - who knows with eBay - depends if DK come clean and tells everyone that the engine cases have been replaced with diecast ones.

Evidently dealers could restamp the replacement cases with the original engine number but most did not bother. They would have to buy/acquire  a set of stamps. The Honda style of stamp was never issued to dealers so certain chracters are a dead giveaway. Vic World via the the Sandcastonly site commented as follows although his comments were about  ANOTHER K0 NOT THE DK ONE ON eBay.



"This is an engine case that has been stamped over here in the US.
 
It is most likely a replacement case-warranty (the blank cases always came from Honda with NO numbers, and it was the responsibility of the Dealer here to stamp the original numbers in). Some Dealers did, and some didn't...depending if they had the incentive enough to go to the hardware store and buy a set of number stamps. (Honda did NOT offer their own stamps to anyone..obviously).
 
The dead give away is the number "9"...this proves these cases in question were not stamped at the factory.
 
From the factory in Japan, the "9" character always had a funny looking "droop" to it (like an over ripe pear hanging on a tree)...and the cases here with "8229" do not have that type of "9".
 
The other foto of the (Factory) cases (#31927) DO have that usual droopy 9..
 
  Vic"


Sandcast guru ChrisR commented yesterday  on the Sandcastonly site on the DK K0 on eBay UK at the moment, as follows:

Quote
"I did see this bike about a week ago at a show. It is a sandcast VIN, but with replacement die cast cases. Correct rear rim, gas tank, recessed switch, front fender (a bit beat up, but solid). Seat base is the worst I have ever seen (only about 50% remains beneath the foam / cover).

As to the price... let each make there own mind up about that!

Cheers - Chris R."

AshimotoK0:
I asked the questions to DK and they have responded and put their reply at the bottom of the listing - basically it is a Sandcast VIN frame but with replacement diecast cases.

Cheers

AshD

Navigation

[0] Message Index

[#] Next page

[*] Previous page