SOHC.co.uk Forums > CB750

finned exhaust clamps

(1/1)

Graeme77:
Is there any well trodden path with these?

Mine are letting the bike down really.

I cant seem to find any more, and i assume there all rusty by now anyway.

Can they be successfuly re-chromed? Or, do people paint them?

Spitfire:
Had mine rechromed, no problems.

Cheers

Den

Hinomaru:
If you're not concerned with performing a correct restoration, consider ceramic coating the clamps. I had my CB750 K done in the polished chrome-like finish back in 2006. The cost (then) was $10.00 (USD) each. Three out of the four still look like new and the fourth clamp is beginning to show a bit of rust between the fins. 

This website gives an example: http://www.jet-hot.com/

Perhaps you have this type of coating service available in the UK?

Yoshi823:
Hadleigh Custom had some ally ones back in the '80s, which I bought as they were featherlight by comparison to the standard ones. But these distorted too much when done up tight. So I cut the finned part off so that I had only the oval section left, then grit blasted & painted with heat dispersnat paint.

Navigation

[0] Message Index