SOHC.co.uk Forums > CB750

carb rebuild anything I should look out for ?

(1/2) > >>

bluemouse1006:
Hi
just got some carb rebuild kits for my K5 CB750 anything I should look out for Ive cleaned all the bodies and will be tackling the rebuild at the weekend .. I see in the kit the needle has slots in it which slot do I set it too with the clip?

any advise much appreciated

Amos  ;D

Bitsa (Ralph Wright - RIP):
Hi,
You do not say if the kits are copies or Honda.I have seen lots on other forums that the copies the needle jets are not the same and can have running problems just as I have.I always thought that the clip goes on the middle ring but alot put it back as they found it.I will soon be fitting new Honda needles and will let all know if it fixed my problem and if so what my problem was with these after market kits.
Good Luck

mick:
Middle slot should be fine Amos

bluemouse1006:
Thanks for the replies  Ill fit them in the middle and see how they go although if I find them all at the top etc ill give that a go,they are copies and not from Honda but hope they will be OK if not ill just refit the old needles etc. back and see how I go

Thanks again

Amos  ;D

bluemouse1006:
started stripping the carbs the main jet on the old carb part seems to be stamped with 105 and the new one has 110 on it does this make a big difference the needle was set in the middle so I fitted the new needle in the same place

Any ideas

Thanks Amos  :o

Navigation

[0] Message Index

[#] Next page