SOHC.co.uk Forums > CB750
Exhaust Stub cross head screw removal
r1_pete:
I have a K2 engine with the cross head screws holding the exhaust stubs in, they look lik ethe type of screw which are a real pain to get out, anyone have any tips?
Also, once removed, does anyone know if F1 pipes will fit?
hairygit:
A decent impact driver generally gets them moving, ;D make sure the driver bit is a good fit in the screw, 9 times out of 10 they'll loosen quite easily, DON'T be tempted to try ordinary screwdrivers, as if the screwhead gets damaged/ chewed, then the problems really start :'(
mick:
Hi Pete i've gone the opposite way and fitted stubs onto a F1 engine with no problems so you should be able to fit an F1 exhaust on there but you will need the
exhaust studs and colletts, cheers Mick.
r1_pete:
Cheers guys, I can make the studs and collets, I just like the look of the F1 4-1, its goimng to finish up quite a bitsa, F2 Chassis, K2 engine, F1 exhaust......
Off to machine mart now for an impact driver.....
SteveD CB500K0:
I've got a set of collets.
I don't know what they're from (other than that they're off a 750...) but you are welcome to them for the postage cost if you want them.
There are 8 of them.
Navigation
[0] Message Index
[#] Next page
Go to full version