SOHC.co.uk Forums > CB750

Exhaust Stub cross head screw removal

<< < (2/2)

mick:
They look like 750 F1 Steve  ;) cheers Mick.

SteveD CB500K0:
The title of the picture is a bit of a giveaway...

K2-K6:
Just to add to the other advice already given, I start by using a broad faced punch (you can use an old socket extension bar) to "peen" the edges of the cross into the gaps slightly. Then if you get the impact driver bit on it's own you can tap it into the screw to get a really good tight fit. Finally fit the impact driver and wallop it with club hammer to make it move before you loosen the fit at all.

As the others have said, these usually don't give too much of a problem as long as you don't round them out.

Navigation

[0] Message Index

[*] Previous page