SOHC.co.uk Forums > CB500/550

head race bearings

<< < (2/2)

mickwinf:
well they are out!! As i dont have a welder i had to grind a mm off the inside diameter of the headstock behind the bearing race just enough to get an old screwdriver on the edge to tap it out.New ones installed with heat/freezer method described by jcknapp, so on to the next job! Thanks for help guys.

kifer:
liking the hair dryer idea thats one for my book, cracking

Tomb:
I use a hair dryer for quite a lot of stuff on the bike, warming fuel pipe to get it on taps/carbs, carb/head rubber whilst inserting carbs.

I might as well use the hair dryer for bike jobs, its got no other use since I'm an old bald bastard now ;D ;D ;D ;D ;D ;D

Navigation

[0] Message Index

[*] Previous page