SOHC.co.uk Forums > CB500/550
Master Cylinder
mickwinf:
this brake is starting to anoy me now! Master cyl has been rebuilt, caliper has been refurbished with new piston and seal and bleed nipple.So i thought i would bleed the brakes, should be a simple job.....I pumped fluid through until no bubbles appeared, then tightened up. Result, no brakes, no pressure on the lever at all.Tried several times but no success.so i have left the lever tied up overnight. What anoys me most is why can i fix a cars brake system which is much more complicated but not this simple bike with one caliper! ah well at least there are others out there with similar problems as many posts seem to be about brakes.
Bryanj:
What i have had to do in the past is put a gloved finger over the threaded oulet hole in the master (pipe disconnected of course) and using the finger like a bleed nipple get the master pushing fluid (finger closing hole, pull in and hold lever, release and replace finger---keep repeating till pressure is felt and fluid squirts not just dribbles).
Then whilst holding the lever in get your trained spider to re-connect teh flaxi pipe an bleed away as normal.
NOTE WELL THE GLOVE IS MOST IMPORTANT UNLESS YOU REALLY WANT TO SUFFER FROM CONTACT DERMATITIS!!!!!! Plus its a good idea to cover over everything that might get squirted.
florence:
...and might I say, avoid those 'self bleed' things. They attempt to save time but usually end up wasting time. There is no substitute for the laborious process of opening the bleed nipple, pulling lever, hold, tighten bleed nipple, then repeat and repeat etc. Takes ages but always works...
Bitsa (Ralph Wright - RIP):
Mickwinf,
Had the same with my 750.What I did was using a pair of grips with rag in the jaws not to damage pipe was to pinch the pipe at the master end and pump the lever until you feel force on the lever then release grips repeating until fluid reaches the bleed nipple.
CAREFUL FLUID BUBBLES OUT OF THE MASTER CYLINDER!!!!!!!
Mine is great this way.
Hope this helps
Bitsa
kifer:
Hi Mickwinf, Not sure if this will help but I always use a syringe and pull the fluid through very quick and no mess. last used when fitting complete new system with no problems. Good luck.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version