SOHC.co.uk Forums > CB750

Carb needle heights ??

(1/2) > >>

bluemouse1006:
 :)
Hi been on my bike today , my mate told me when he followed me my bike really smelt rich , I've replaced all the jets and needles in all 4 carbs . I have adjusted the air screws ( screwed all the way in and then out until the idle picks up ) this was about 2.5 turns out ..
I fitted the needles on the second slot from the top like the old carbs were . Any one know if this is about right ?
If I was to drop it a slot would that make it better ? Runs fine when warm but a pig when cold ( see my other topic) how far should you screw those air screws out is 2.5 too far ?

Cheers again

Amos

Spitfire:
I can't remember where I got this (probably from the US site) but it might help.

Cheers

Den

mick:
Hi Amos put the clip in the middle slot & set the air screw as show on the chart Den has posted  ;), cheers Mick.

bluemouse1006:
Cheers

I'm going to look at the plug colour before having a task and a half stripping the carbs
Just a quick one is two slots down in the middle anyway ? It ll save me stripping if that's the case.

Thanks again

Amos

Spitfire:
Here's a nice discusion of the subject from the US site.
http://forums.sohc4.net/index.php?topic=63177.0

Cheers

Den

Navigation

[0] Message Index

[#] Next page