SOHC.co.uk Forums > CB750
Taking Comstars to bits --- Again.
Tomb:
--- Quote from: Tomb on June 21, 2012, 07:56:57 PM ---The route I'd take is trying to fit a second disc to the CM400 wheel, aren't most Honda wheels drilled right through so a disc can be fitted to both sides? even if they ain't I'd do it, the CM400 has a cover over the non-disc side, I wouldn't take that off coz it'd mean removing the pegged nuts but the centre of it could be machined out and the hub drilled and tapped, and the disc spaced out with spacer disc.
--- End quote ---
guess not then ::)
r1_pete:
Hi Tomb, No the cast in lugs for the disc fitting are only half width on the cm400 wheel.
Cheers.
Pete.
Tomb:
bugger!! :o
K2-K6:
As already discussed, it's a noted specialised area as the localised demands are so high that if you do get it wrong it's probably going to be a very quickly occurring failure. I for one wouldn't want to be sitting on it when it did.
On a positive note though the CM400 wheel is from which model? as far as I can remember the bike I know as the "Superdream" had twin discs fitted to the 400 model and not the 250 which could have been 18" rim size, so may be a scource for you.
matthewmosse:
19 on the superdream front wheel, the cover on the other side to the disk unbolts to allow twin disks on the 250's I've had my grubby mitts on (the wheels are still awaiting being remade into a horse drawn convayance in my garden)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version