SOHC.co.uk Forums > CB750

k7, k8 quick question

<< < (2/2)

UKROBK7:
Thanks all!  I have attached a photo of the bits that I am in trouble with. 

It originally looked like the vertical part of the pipe ran up the frame and you would unclip it to drain the trapped oil (there should be a plug in the pipe which is missing but is available from DS.  Problem with this is I can't see how to avoid the crankcase or the rear breather tube.  The pipe could also be rotated and bent to run along the rear swing arm but this does not seem right.

The CMSNL drawing shows the pipe pointing towards the rear of the bike and downward but this does not fit either!

Rob

mick:
Does the long black pipe not go down and over the swinging arm? looks like its shaped to go somewere? and there is usually a guide bolted to the back of the engine for overflow pipes etc to run through,  ;)cheers Mick.

UKROBK7:
Mick, the guide is too small to take the long pipe.  I have just bolted the breather pot into place and will try the pipe in various positions to see what I can come up with.  It might actually be shaped to go round the rear crankcase breather pipe.

cheers Rob

UKROBK7:
Sorted! Posted on the US site and the reply is that it wraps over the front of the swing arm and is held by a bracket.  It then goes backwards to a bracket on the RH silencer bracket.

Rob

Navigation

[0] Message Index

[*] Previous page