SOHC.co.uk Forums > CB500/550

Speed wobble

(1/2) > >>

anparkinson:
If I take my hands off my bars on my 550K3 at between 40 - 50 mph the bars start wobbling until it wants to tank slap.

I have checked the wheel alignment, had both wheels rebalanced, checked and adjusted headstock bearings, checked tyre pressures but no difference.

My friend's identical K3 doesn't do it so it is a problem with mine.

Any ideas (apart from not letting go of the bars)???

LesterPiglet:
How old and what type are the steering bearings. My stock "balls"  :o looked ok and were adjusted properly but I was at my wits end trying to sort a weave. I decided to buy new tapers and that fixed it.

anparkinson:
I think that's the way to go.  That can be my winter project....

basketcase:
I`ve fitted taper bearings and there was still a slight weave at speeds, I`ve put it down to the tyres. Saying that, I`ve also fitted bar end weights and that has taken out a lot of it.
Just my pennyworth!

florence:
Are you sure your bearings are adjusted correctly?  When I rebuilt mine, it had terrible steering.  It turned out that I hadn't quite located the top yoke properly.  It looked fine but the bearing kept loosening itself.  The friendly MOT man pointed it out.  We loosened everything a little, tapped it all round with a leather mallet, then tightened everything.  It has been lovely ever since (17yrs).

Incidentally, I fitted new standard bearings and they are perfectly good and easy to put in.  I'm not convinced about taper roller bearings.

Has the bike always been like this or has it developed this habit recently? 

Navigation

[0] Message Index

[#] Next page