SOHC.co.uk Forums > CB750

Phillips head bolts ??

(1/3) > >>

cb750stu:
Hi Folks i am going to replace all the allen head casing bolts with original phillips head bolts for the clutch,generator cover etc,

Whats the best way to torque these up is it with a impact driver(i think thats what there called) the one where you tap with a hammer ?? Like this one
http://www.toolstation.com/shop/Hand+Tools/Screwdrivers/Impact+Driver+Bits+13+Piece/d10/sd80/p46592

Any suggestions cheers

Regards
Stu

kifer:
I would not use an impact driver if you want to torque them use a normal torque wrench with either correct bit in socket or bit holder I find 3/4"  drive handy on bikes.

cb750stu:
Cheers Kifer i'll go and get a socket for my torque wrench on Moday !!!

Regards
Stu

steff750:
 :) i also replace any Allen socket bolts with the original crosshead bolts, but be careful they are not the Phillips size heads .they are Japanese industrial standard and not as deep as Phillips screws, and made to slip if over tightened so just nip em up,and you only need an impact driver to get em out   :o

Bryanj:
Kifer, i think you mean 3/8 drive not 3/4!!!!

Navigation

[0] Message Index

[#] Next page