SOHC.co.uk Forums > CB350/400
Carb manifold woes!
steven400/4:
1 and 4 are the same 2 and 3 are the same inlet rubbers are the same if they are not in the right place the chamber wont line up right not sure how to tell whitch is witch tho sorry
steven400/4:
ir you need a hand i can come over i,m not far from you
buxtonmick:
Thanks Steven - it's a fair trek from Burton! I'll bear that offer in mind when things get really tough though. Here's a couple of pics to try to indicate the problem, with the rubber on no 1 cylinder seeming to be slightly too short to reach when the others are in place., and as I say, it doesn't help that it is slightly harder rubber than the others.
ST1100:
--- Quote from: buxtonmick on November 21, 2012, 01:05:08 PM ---...it doesn't help that it is slightly harder rubber than the others.
--- End quote ---
Have you tried removing the air filter housing, reaching through the intake hose into the air box and pushing the front wall at #1 forward?
Had a very similar issue on a 650 and above method did the job.
buxtonmick:
;D Yep, but even when I get it more or less on it pops off again! Definitely a problem with it so I'll see if I can get hold of another airbox - there's a couple on ebay at the moment (one looks a bit ropey though...)
Thanks, Mick.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version