SOHC.co.uk Forums > CB750

K2 Handlebars - E (nglish) spec?

(1/2) > >>

Lobo:
....I ask because the brake master cylinder rubber boot pushes moderately hard up against the tachometer. (I've ensured the enclosed 'oil bolt' has clearance)

The handle bars appear OEM, with the loom cut-outs, punch markings (to line up) etc. I've installed them iaw the punch marks.... and am left with this squashed protective boot.

Can't believe Honda would have planned this - help / comments?

Ta.

Waggles:
Think a pic might help, maybe you have something non-standard? Don't have a K2 myself but it doesn't sound right, there isn't a lot of space / clearance on my F1 ( which definitely does have standard bars ) but it doesn't touch. Is the master cylinder reservoir vertical? is a brake line too short and pulling the mastercylinder out of line?

Lobo:
Here ya go...

Just to re-iterate, the brake cylinder 'hardware' is actually clear of the tacho by 5mm or so, but the rubber boot is somewhat squished.

All the adjustments are at extreme, assuming I don't want to ride with the brake lever vertical!

All-in-all not overly concerning, just can't believe Honda would have designed it thus & so wondering if I'm missing something obvious. (oversize after-market brake cylinder, aftermarket instrument mount etc etc)

(Notably the clutch cable is a little long...but I guess to cater for the higher bars American models?)

Lobo:
Thanks OddJob... and darn, the bloody hours I spent last summer re soldering the starter button / re-threading the looms into the 'bars.,.

Visually they look identical to the DSS offering, and coupled to this I do remember reading a thread (elsewhere) about how the UK spec bars had the master cylinder tight up against the tacho.

I've just measured the longest length across the bars (inc rubber grips) @ 28". Anyone care to give me the definitive UK measurement?

Finally, surprised (& disappointed) as this bike always been UK spec, and only one owner 'til me last April. Knew bits had been renewed / reconditioned - but never suspected the 'bars.
Cheers.

Lobo:
...just found this old ad for English spec "Original Honda Bars" quoting # 53100-300-610, and although the angle perhaps deceiving they look like mine... tho' maybe (?) a tad more angled. Will try a photo tomorrow from same perspective as the ad...

Navigation

[0] Message Index

[#] Next page