SOHC.co.uk Forums > CB750

CB750F1 CARBURETOR

<< < (2/2)

Brian59:
Thanks for that tip cheers.

Waggles:
Did exactly the same thing on my F1 during the rebuild  :-[ my carbs were found to be so gummed up with what looked and felt like sandstone that the decision to replace them was easy, I would go the e-bay route. However, for interest, and in case you don't find any for a while I did post on the US site and apparently some have had some success using an epoxy like JB Weld. Its not a stressed part really ( till you try and remove the pin  ;D ) so its only a matter of whether fuel will affect it, apparently its OK. Could be worth a try if you are stuck. Would keep an eye on it though

Spitfire:
Broke one years ago and glued it back on with Araldite, worked a treat.

Cheers

Den

Navigation

[0] Message Index

[*] Previous page