SOHC.co.uk Forums > CB350/400

CB400F2 Tank Decal positioning

<< < (2/2)

Lobo:
... can anybody out there with an F2 just nip ot to the garage & confirm basic measurements ??? Please!  (I'm beginning to suspect the measurements way out for the F2)

Don't need to the mm, just a "yup, that fits with the F2" will do.

Don't want to end up with something that looks a bit 'odd', as this job does..

sweetpeauk:

--- Quote from: Lobo on April 07, 2013, 06:27:31 AM ---... can anybody out there with an F2 just nip ot to the garage & confirm basic measurements ??? Please!  (I'm beginning to suspect the measurements way out for the F2)

Don't need to the mm, just a "yup, that fits with the F2" will do.

Don't want to end up with something that looks a bit 'odd', as this job does..

--- End quote ---
Will pull out a yellow nos tank and have a measure for you.

sweetpeauk:


Right then
please note I am using a tape from the 100mm mark as my 0mm

Corrected
Bottom of stripe decal from base of tank 23mm

front of tank to bottom corner of stripe 65mm with tape pulled straight, not following contour.

end of top stripe (rear part were it tapers down) to bottom of tank 139-140mm

Honda decal height from bottom of top decal line 20mm From front of tank to top left of H 145mm with tape pulled straight, RHS top right of A 148mm to front

supersport decal 9mm from bottom of honda decal. with S in line with centre of the O in Honda.

Lobo:
Blimey SP!

That's well beyond the call of duty. Fantastic, thanks very much, a beautiful tank you have there.

Simon

Navigation

[0] Message Index

[*] Previous page