SOHC.co.uk Forums > CB750

damaged cooling fins

(1/2) > >>

ianmck:
can anyone give me some advice, I have a couple of damaged cooling fins on the engine, any ideas on repairing them, the engine is out but I dont want to strip it if poss.

Bob Wessner:
I used an epoxy clay to replace a chunk out of the very top fin on my 750. That was about 6 years ago and it's still there, no problems.

Bob Wessner:
Finally found the thread where this was discussed (U.S. Forum) and the product I used. Hope it is of some help.

http://forums.sohc4.net/index.php?topic=19402.msg202306#msg202306

ianmck:
Bob you are a star, thank you for your efforts, I will try to find the same or something simmilar over here. thanks again, Ian.

Bryanj:
Devcon, if its still made, used to do a metallic based epoxy putty for all the different metals

Navigation

[0] Message Index

[#] Next page