SOHC.co.uk Forums > CB350/400

cheeky seal question

<< < (2/2)

ashewan:
In the end I used a lot of rubber grease in the seal channel; that held the o ring in place and then screwed up the bowl. This morning I took off the bowl, wiped away the excess grease and the o ring has stayed in place!
Cheers
Andrew

Update: Did the above on the remaining carbs and has worked a treat.

Lynx:
I put a few dabs of clear silicone instant gasket into the o-ring groove, leave it a minute to start setting. Then fit the o-ring and float bowl. No problem.

Navigation

[0] Message Index

[*] Previous page