Other Stuff > Tricks & Tips

Removing Roller Bearing Seats from Headstock

(1/1)

Ewan 500 K1:
Procedure captured in photos below:

Photo 1: Bearing seat in top of headstock
Photo 2: Nifty wee bearing seat removal tool
Photo 3: Tool in place on top of headstock
Photo 4: Drift inserted from bottom of headstock
Photo 5: Couple  of whacks on the drift with a rubber mallet and the bearing seat is out

Repeat at the other end to get the bottom seat out ... bit more tricky as this seat's diameter is about the same as the headstock inner diameter and may be flush into the shoulder, so next to nothing for the tool to grab onto. Expand the tool as much as possible and the first couple of thumps on the drift should move it enough through friction to get a gap between the seat and the shoulder it sits in for the tool to get a better grab on it

matthewmosse:
That is a neat tool, I've always resorted to a bead of weld on the bottom race but this does rather destroy it!

Ewan 500 K1:

--- Quote from: matthewmosse on August 23, 2013, 09:25:14 AM ---That is a neat tool, I've always resorted to a bead of weld on the bottom race but this does rather destroy it!

--- End quote ---

I think its an old suzuki workshop tool, Sealey do a similar tool: Sealey Tools MS040 Motorcycle Steering Stem Bearing Race Removal Tool.

just over £20 on ebay http://www.ebay.co.uk/itm/Sealey-MS040-Motorcycle-Steering-Stem-Bearing-Race-Removal-Motorbike-Tool-New-/310674057778

Navigation

[0] Message Index