SOHC.co.uk Forums > CB750

Cam chain question ??

<< < (2/2)

hairygit:
Only if they exceed 2thou inlet and 3 thou exhaust! But, do consult a manual as to the exact engine position for checking each tappet ;D

cb750stu:
Cheers mate when i have it lined up with the mark they wont budge at all ??

I take it that the exhaust are at the front and inlet are at the back of the engine ??

Cheers

Bitsa (Ralph Wright - RIP):
Stu,
Turn engine over until you see the inlet valve open then close on number 1 cylinder (carbside) and then line the T on the line.Both tappets should have play on them.Then turn until spring spigot is lined up,it wont be much then adjust camchain.
Hope this helps
Cheers
Bitsa

cb750stu:
Cheers Bitsa the above seemed to have worked when I undid the lock bolt it did move in a tad so I take it it was taking up the slack then I just did up the bolt again !!!

Cheers

Bitsa (Ralph Wright - RIP):
Yup
cheers
Bitsa

Navigation

[0] Message Index

[*] Previous page