« previous next »
Pages: [1]   Go Down

Author Topic: Carb Question ??  (Read 3913 times)

Offline cb750stu

  • SOHC Expert
  • Posts: 262
    • View Profile
Carb Question ??
« on: October 20, 2013, 04:17:28 PM »
Hi Folks I was wondering is there a specific measurement for the gap between the slider when it bottoms out in the body of the carb ?? I found this pic on a website but there is no measurement stated ??

Cheers Stu.

Logged
1976 CB750 F1 SS in bits !!! but getting there

Offline SteveD CB500K0

  • Administrator
  • SOHC Jedi
  • Posts: 4661
  • Ride on the Steel Breeze...
    • View Profile
    • Steve's Blog
Re: Carb Question ??
« Reply #1 on: October 20, 2013, 05:03:17 PM »
I use a good old-fashioned 1/8" drill bit.

That wire looks too thin to me.
Logged
1971 CB500K0

Offline mick

  • SOHC Master
  • Posts: 1464
    • View Profile
Re: Carb Question ??
« Reply #2 on: October 20, 2013, 05:22:56 PM »
I also use a 1/8th drill bit  ;) cheers Mick.
Logged

Offline steff750

  • SOHC Expert
  • Posts: 462
  • THE POWER OF DREAMS
    • View Profile
Re: Carb Question ??
« Reply #3 on: October 20, 2013, 07:02:31 PM »
 ;) OK as a static guide or bench rebuild you will still need to use gauges to sync the carbs once the bike is up and running happy days
Logged

Offline cb750stu

  • SOHC Expert
  • Posts: 262
    • View Profile
Re: Carb Question ??
« Reply #4 on: October 20, 2013, 07:18:02 PM »
Cheers Guys,
Logged
1976 CB750 F1 SS in bits !!! but getting there
Pages: [1]   Go Up
« previous next »