SOHC.co.uk Forums > CB500/550
Loom and part i have labelled but ink faded
Trigger:
Can you see the rubbing marks on the frame Mike. Does this line up with the damaged part of the loom/harness?. If it does, then that's the problem. It may look bad due to the corrosion . Chop it out ,cut it back and replace the damaged wire.
MIKE550/4:
trigger that pic is old, frame has now been powdercoated.
Electrics I will be reading up on to try and gain some knowledge
looking at the loom again its towards the end of the loom
Trigger:
Mike this is a simple repair. I am just trying to find out what created the problem in the first place, because you don't want it happening again. There is a rubbing mark on the frame (before powder). If you line the loom up on the bike and the damage matches up with the rubbing marks, then you know what made the damage. I have seen this before and it is when the loom is not positioned right.
Bryanj:
That green wire, which has a ring connector at the coil bracket, can get hot and melt if the main earth wire does not make good contact at the R/H rear engine mounting---any paint/powdercoat need to be removed on both sides so bracket contacts engine and lead properly
MikeM:
another question on this, took this to motor factor but they could not answer me.
basically what wire do i buy to be able to replace this with ?
anyone give me a link to ebay or the like ?
thanks
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version