SOHC.co.uk Forums > CB350/400

To rubber grease or not to rubber grease, that is the question

(1/2) > >>

Drew400:
Hi all,

In my limited experience of such matters, I routinely use rubber grease when installing new seals, etc. Is this adviseable for rebuilding my 400/4? I'm thinking specifically about the front fork leg seals.

Thank you,

D.

steven400/4:
when fitting mine i put some fork oil on them at it worked for me with no problems

LesterPiglet:
I just use fork oil as well. For other seals I lubricate with whatever they are supposed to keep from leaking.   :)

Trigger:
OK, a little trade secret. Turn a seal over and it has a recess. Find a O'ring that is a tight fit in he recess and squeeze it in. We always had problems with the clutch lever seal and came up with this idea to tighten the seal to the shaft. Never had a leaking engine seal ever again. Never tried it on a folk seal.

LesterPiglet:

--- Quote from: trigger6969 on February 17, 2014, 07:32:36 PM --- Never tried it on a folk seal.

--- End quote ---
That's at the front of the boat isn't it?   :P

Navigation

[0] Message Index

[#] Next page