SOHC.co.uk Forums > CB750

My version of a Hydraulic clutch conversion

(1/2) > >>

r1_pete:
I fancied having a go at a hydraulic clutch for a while, no real reason other than to be a bit different, I've seen many using a triangular type plate, but couldn't see how it was centred....
So came up with this, which centres on the original cover lip, I'm quite pleased after 3 or 4 hours on the lathe its turned out perfectly centred.
Next job is to plug the kickstart hole, then start polishing.

JamesH:
Really nice work there pete. What's the donor hydraulic actuator from?

MarkCR750:
Excellent job, have you removed the kick start permanently?.

hairygit:
Nice bit of lathework there! But, I am very curious as to how the oilpump is going to work without the kickstart shaft, have you shortened the shaft, or some other incredibly cunning plan?

r1_pete:
The slave is from a CBR1000 but its pretty common across the Honda range.

The kick starter will be permanently removed, I'm going to cut the shaft a couple of mm short of the oil seal and press in an alloy blanking plug with a smear of Loctite.

Navigation

[0] Message Index

[#] Next page