SOHC.co.uk Forums > CB750

K1 top yoke

(1/3) > >>

JB373:
Hi - I have a 71 K1 project on the go and I am going run clip ons so want to grind the top yoke down for some cleaner lines but rather than chop up the original (rhino horn shape) which look like they're quite rare, does anyone know if any other model top yokes fit the K1 - I did buy a later cb750 model top yoke off ebay for not very much but it didn't line up -anyone have any suggestions...please?
Thanks

mick:
Hi I'm not 100% sure but I would have thought one from a K6 or F1 would do? cheers Mick.

Bitsa (Ralph Wright - RIP):
Plus 1 with Mick but I would think all the ks up tp the 6 would do.
Cheers
Bitsa

hairygit:
I don't think an F1 item would be much use, it would fit, but has the speedo/tacho mounted differently to the K1-6 (little chrome clamps for K1-6, two little acorn nuts on the bottom of each clock for F1)

MarkCR750:
Removing the handlebar bosses on the top yoke that was fitted to my K6 or K7 (not sure which model the top yoke was from) would leave 2 large holes, I would question the integrity of the yoke once this had been done, I have ordered a CR750 replica top yoke from Honda Racing ltd £108 , I'm told a Cbx1000 top yoke is a straight swap though, depends what look you are going for.
Re the Honda racing ltd Cr750 top yoke below you send them your top yoke and they machine their casting to match.

Navigation

[0] Message Index

[#] Next page