SOHC.co.uk Forums > CB500/550

k3 throttle cable pulley

<< < (3/4) > >>

MikeM:
arrghh getting frustrating now

pull to top .....

closing cable on bottom holder

top cable over the top of pulley and nipples pushes sideways into the hole

bottom cable ( close ) under the pulley in the groove of pulley and nipple sits sideways in the groove

end result not able to move throttle on grip, I am obviously doing something wrong, read manuals supplement and seem to be doing it correct

so guys any more ideas hope the vid helps it to show better

MikeM:
https://www.youtube.com/watch?v=u-53LnbeuAU&feature=youtu.be

matthewmosse:
tried swapping the cables over inside the twist grip? Or taking the twistgrip off the bars. Seems very odd, might be something binding somewhere, taking the twistgrip out of the equation might help figure out the culprit.

mickwinf:
Just a thought, does the opening cable go on the bottom of pulley, try swapping them around.

MikeM:
just loosened off the throttle stop and the cables now move, quite hard to move but maybe easier with the rubber grip on the throttle

I guess I now have to set it up ?

Navigation

[0] Message Index

[#] Next page

[*] Previous page