SOHC.co.uk Forums > CB500/550
500 engine strip
kenny1059:
Done!! :)
If anything, I was compressing spring to much. But doesn't matter now,as they are in and seated with the help of a rubber mallet. :) :)
Kenny.
Trigger:
Well done Kenny. See if you try it all happens in the end.
Trigger:
Before putting the head back on check that all the valves are seated. By testing them with fuel down the ports. Do not know if you have re-cut the seats and lapped the valves in???
kenny1059:
Nice one Oddjob. :) :) :) :) :) :)
Lapped valves etc. yesterday. All is o.k. :) :)
Kenny.
mickwinf:
More progress, got the valves installed with my new spring compressor (ebay £20) fitted the head with genuine Honda gasket. Just the rocker top to install then engine is complete ready for carbs and exhaust. Cant wait for the first start up!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version