SOHC.co.uk Forums > CB500/550
Triggers bucket
Ewan 500 K1:
--- Quote from: Norniron400f on May 07, 2014, 10:03:50 PM ---The two types of arm ,on the bottom is a k3 arm
--- End quote ---
On a tangent ... do those two have different horozontal offsets ? ... I had a right bugger of a time setting up my dual discs ... i think beause I was using two different caliper arms. Of the three I was trying, one has 5 5 stamped on it, one has 8 8 stamped on it and one has M2 stamped on one side and an 11 on the other. Of the three, one is distinctly asymmetrical in the plan view, ie it bends more one way than the other horizontally . The other two are symmetrical. Also, one is of thicker diameter than the other two at the end where the pivot pin goes through it.
Norniron:
Your calliper is 50mm bolt centres.change it to the smaller calliper and arm and i rekon its sussed
Norniron:
--- Quote from: Norniron400f on May 07, 2014, 10:03:50 PM ---The two types of arm ,on the bottom is a k3 arm
--- End quote ---
I ve lined them up so the fork mounting bolts are in line for the pic.
Trigger:
Ewan, the K3 and F share the same part number on the left fork case. I still have the old pads from this caliper and if it was like this before there should be a worn step in the pads. But they are flat and smooth.
matthewmosse:
is it possible the top bit of the pivott is on upside down and throwing things out?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version