SOHC.co.uk Forums > CB500/550
Triggers bucket
Trigger:
I will measure it up against the 500K0 folks tomorrow.
Trigger:
Nope, not a 750 caliper. They bolt from the back to the threads in the main body. Bitsa, sent me a 750 arm and that is 42mm.
Trigger:
Cheers oddjob, will try again tomorrow. The F1 i have just sold had the same caliper. I have it in my head that there was two types, one being a wide body.
Ewan 500 K1:
--- Quote from: Oddjob on May 07, 2014, 10:58:24 PM ---It's the wrong arm and caliper Trig. Just compared it to a 500/550 arm and it's different. The 500 arm doesn't have a slope on the bottom, it has raised edges on top and bottom and no segment like a slice of cake on the lower edge like the one in the pic has. Plus the caliper looks different and the bolt holes are too wide apart on yours. It's the wrong one Trig, no doubt at all in my mind.
--- End quote ---
agree here., just been out and measured mine ... caliper bolt holt spacing is 42mm. I also have a spare caliper arm in ma boxobits ... it is 50mm between aliper mounting holes and when I line it up against the fork mounting points, it sits a good bit higher than the 42mm bolt spacing ones do . The 50mm one is marked "ART" on one side and "5" on the other .. any idea what its off Ken ? Also agree the inner face of the caliper looks wrong.. or different to mine anyway. I reckon NOrn is right too... swop caliper and arm out for 42mm bolt spacing versions and sorted
Ewan 500 K1:
--- Quote from: Norniron400f on May 07, 2014, 10:28:48 PM ---
--- Quote from: trigger6969 on May 07, 2014, 10:21:06 PM ---Norniron, so which arm is the top? if the bottom is K3.
--- End quote ---
Cb500 so ive been told
--- End quote ---
dont think top one is a 500/550 one Norn.. should be a valley between adjuster bolt hole and bottom edge (see pic for mine) . I think all the 550 and 500 models share the same arm .. although there are two part numbers they appear interchangeable - 45115-323-010 & 45115-390-003 according to http://www.motogrid.com/p/OEM-Parts
One on top in your pic has a has a raised bit instead of a valley. Does the top one in the pic have 50mm caliper mounting bolt spacing... looks like wider spacing in your pic than the bottom one
What is this bleeding version with the 50mm bolt spacing from ?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version