SOHC.co.uk Forums > CB750

Clutch adjustment problems

(1/2) > >>

rich:
Was wondering if anyone can help with a clutch problem.  I change the clutch in a 750 and the springs seem to be compressing to far and the throw out bearing won't reach the clutch when engaged.  I have torqued the plate to the proper torque, but it bottoms out against the back side of the pressure plate.  The way it looks to me is the springs should hold the throw out bearing off, so ther is no metal to metal contact.  The spring measurement is long enough according to the book.   Do these springs lose there tension?
Help!  
Thanks Rich

JonnyB:
Hi Rich,

Is this an early clutch, all the ones I've seen are for the F1,

I would have thought that even if the springs were on the weak, while the engine was not running clutch operation would still work.

Dumb question coming......

You have the correct number of friction and plain plates. don't you?

I had a look in the Haynes, and the reassembly looks a lot more complicated on the earlier clutches

rich:
John, Thanks for the reply.  There is the correct amount of plates, etc.  It appears to me that the springs are compressing to far and don,t have enough resistance to hold the torque.  However the spring measure well over the static measurement.  I don't know if they had a problem with these springs not holding there value.  This is a 1974, and it is a simple change or so I thought.  Any help would be greatly accepted.
Thanks Rich

3Rydez:
I'm having the same problem with my 1974 CB750 clutch. Anyone have any ideas.

rich:
I ask some other people about this clutch problem and the mechanic from Walneck's (US mag) came up with the answer.  You have to rotate the clutch plates on the four screws and spring and somehow this works.  They all appear to be the same in every manner (size etc), but for some reason this is the answer.  If you can't get the adjustment, just remove the clutch and pressure plate and rotate it a quarter turn and try it again, and a quarter turn and try(you get the idea).  I personally still can't believe this had worked, but it did.  Hope this helps you!!!  Rich autotinman@zoominternet.net

Navigation

[0] Message Index

[#] Next page