SOHC.co.uk Forums > CB500/550
engine stud
MikeM:
least I have all the correct stuff to fix........
what about swarf going into engine is that going to be likely outcome ? ..... any tips to avoid that.... just done a top end rebuild and don't really want to start pulling the head
Bitsa (Ralph Wright - RIP):
Thats as bad as the last cam tower bolt.Do it up and it strips right pain in the butt
Good luck
Bitsa
Bitsa (Ralph Wright - RIP):
Make sure the exhaust valve is shut on that cylinder then when repaired air it out
Cheers
Bitsa
Trigger:
I use milk carton/ container tops. The round ones fit nicely in the port holes.
Trigger:
Just emailed you a picture on how to use the tops Mike.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version