SOHC.co.uk Forums > CB350/400

Exhaust split collars

<< < (2/2)

Lobo:
Greg... don't know what your alternative forum had to say....  but if you do decide to re-new the set, beware. 

I ordered a new set of these from DSS and they were about 10mm too long.... meaning I couldn't get enough thread from the studs to tighten down the finned collars.  Ie the hack saw had to come out onto the new split collars.

Cheers,
Simon.

Greg65:
Thanks Lobo. As I was putting in a new exhaust I was inclined  to replace them, however as their job is to transfer the pressure from the finned clamps to the exhaust flange ensuring the new gasket seals. I think I will wait and see what condition the old ones are in.

ka-ja:
Hi,
    Had mine coated with industrial chrome plating, fairly cheap and looks like cadnium plate----ken

steven400/4:
make sure you dont get the big one,s [10mm] to long when you order them as for the u s ones they are smaller and no need to cut them down plus if you look at the parts number in the book there is to numbers one number for big set one number is for the small set  ;) ;) ;)

Navigation

[0] Message Index

[*] Previous page