SOHC.co.uk Forums > CB750

CB750K2 Master cylinder rebuild

(1/1)

philward:
Hi Guys
Just got rebuild kit for master cylinder (from Silvers) and bit puzzled by washer supplied with kit. Schematic shows '10.5mm washer'. The washer that's with the kit is less than 10mm ID which won't fit over piston shaft and OD is too big to fit in the cylinder. Is this washer supposed to fit between the master cylinder body and circlip? (as per schematic shows), if so it won't fit. I don't have original internals - as my previous posts, bike bought completely in bits and cylinder was bare.
When this is solved, just have to figure out how to get that bloody circlip in!
Thanks

Bryanj:
Sounds like the washer is wrong, i would ring DS and tell them as he likes to know about any problems

mickwinf:
I had the same problem but had my old washer and used that.

billy192:
me too, i used a dremell to make fit.
Billy

tom400f:
I used this to do my circlip http://www.amazon.co.uk/exec/obidos/ASIN/B0034A6B6K

Navigation

[0] Message Index