SOHC.co.uk Forums > CB350/400

How to repair a small tear in the seat cover

(1/2) > >>

DayvW:
I wonder if anyone has any tips for repairing a small gash in my (400-4) seat cover.  The seat is original and I'd like to keep it if possible (I have replaced the strap and buttons as they were quite corroded).  Any hints and tips gratefully received.  Many thanks.

Trigger:
The small tear will only get bigger. Put a new cover on, Dis-covers should do a replacement cover.

mickwinf:
or try a car smart repairer who does repairs on dashboards and upholstery

Bodd:
These guys do some good covers, I got my RD250 cover off them and it was excellent.

SteveD CB500K0:
I have seen this done (my boss did it with a small tear in his VFR750 seat).

1. Turn the seat over. You should have a small amount of spare material where the cover has been stretched and stapled.
2. Cut off a small piece of the spare material - enough to cover the tear (like a puncture repair)
3. Carefully push the spare material into the tear. Use a matchstick or the blunt end of a plastic spoon.
4. Once the material is between the tear and the foam, superglue around the edges.

This makes a waterproof and almost invisible* repair.

* Disclaimer...   The "invisibleness" of the repair is directly proportional to the amount of care that you use. Do not use too much glue as it will show through the remaining tear (where the edges don't quite meet).

Good luck.

Steve

Navigation

[0] Message Index

[#] Next page